Write a Review

Product Overview

Easy as 1,2,3…

Instructions for use:

1. Clean both the metal and the glass with 100% acetone. NO SUBSTITUTES.

2. Use the eye dropper to apply the ACTIVATOR on both of the surfaces to be bonded. Activator will form a thin wet film in about 3-5 minutes. Do not touch Activator. Always put poly-seal cap back on after use or the Activator will evaporate. Place eye dropper in a clean Zip-Lock.

3. Apply ADHESIVE to the stand-off. When the stand-off is placed on the glass the adhesive should spread out and cover the entire surface area. Adhesive will set in 5-10 minutes and cure in 48-72 hours. Clean up excess adhesive around sand-off with acetone.

Notes: To speed up the set and/or cure time increase the temperature in the room, not direct heat from heat gun or hair dryer – this will make your application brittle. Keep your adhesive in refrigerator when not in use.

2 dram size of each.